![]() ![]() No service timestamps debug datetime msec ![]() VLAN Type SAID MTU Parent RingNo BridgeNo Stp BrdgMode Trans1 Trans2 %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan30, changed state to up %LINK-5-CHANGED: Interface Vlan30, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan20, changed state to up %LINK-5-CHANGED: Interface Vlan20, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan10, changed state to up %LINK-5-CHANGED: Interface Vlan10, changed state to up ![]() SWITCH#conf tĮnter configuration commands, one per line. In CLI, execute the configure terminal command and then the interface command (name of the vlan) to configure the corresponding VLAN. To add management addresses for VLAN10, VLAN20, and VLAN30, addressing the network topology, follow these steps: In the Switch, this operation is performed in the settings of the VLAN you will assign IP.Ī management IP can be assigned for each VLAN created. The ip address command is used in the configuration mode of the port to assign an IP address to the interface of a router. ![]() Assigning a Management IP Address to VLANsīy granting a management IP address to VLANs, you can control your devices from the local or remote network. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |